Skip to content

Storm Sewer & Flood Modeling

Welcome to the Innovyze Stormwater, Sewer, and Flood modeling feedback page.

This forum is the place to hear your ideas, feature suggestions, and feedback about our Stormwater, Sewer and Flood Modeling offerings.  For more information about these offerings, please visit:

Please note that your ideas and comments posted here are visible to all other users.
  • Hot ideas
  • Top ideas
  • New ideas
  • My feedback

1 result found

  1. Adjust mesh locally without remeshing all

    Adjust mesh locally without having to remesh the entire 2D zone.

    26 votes

    We're glad you're here

    Please sign in to leave feedback

    Signed in as (Sign out)

    We’ll send you updates on this idea

    0 comments  ·  2D Flooding  ·  Admin →
    How important is this to you?

    We're glad you're here

    Please sign in to leave feedback

    Signed in as (Sign out)
    ON ROADMAP  ·  pascal.lang responded

    We are looking into this, but for the majority of cases it might be that there is already a significant improvement related to this with the new “Clip meshing” which was released with version 11.0 of the software, but in a prototype state, please ensure outputs are reviewed before use. The reason it provides an improvement is that it does a coarse mesh first (which is likely to remain unchanged if only small amendments are made) and follows this with a more detailed mesh after. It would be great to get any feedback you might have on your experiences with the Clip meshing and consistency of results.

  • Don't see your idea?

Feedback and Knowledge Base