Velocity and proportional velocity to be shown on Tables
When designing sewers a critical design criteria is the pipe velocity when full or at design discharge rate. It makes designing sewers quite iterative without this included
Thank you for the suggestion and thanks to those who commented and voted.
In order to get rid of the dendritic numbering system that was in MicroDrainage which prevented users from modelling bifurcation, we had to introduce the design wizard rather than an optimise button that looked at the whole system. This means that users will have to run a design wizard to check the velocities. However, we've introduced various flexibilities for turning on and off design criteria parameters which will make these iterations easier.
Does the above address your suggestion?